Got the "TV made EZ" kit from Bowtie Overdrives.
The old cooler lines had to be spliced with new ones since I had to cut them to get the TH400 out. I had the drive shaft shortened by 2 1/2 inches, and I'm still kicking myself for not getting a quick release yoke for tail end of the tranny, because it was hell to put on without it. I kept the factory cross-member, had to use the dremel again to make new mount holes, because even with the special tail housing, it mounts about an inch too far back to use the original holes.
I went ahead and used the old transmission's rubber mount for the 700R4, which, with the special tail housing with the two areas for bolts, hooked right up after some attention on the mount from my dremel tool.
0 kommentar(er)
